2012

INSNAME
Sets a default block name for the INSERT command.
StringType:
Not-savedSaved in:
""Initial value:
The name must conform to symbol naming conventions. Returns "" if no
default is set. Enter a period (.) to set no default.
See also:
Insert Blocks
INSUNITS
Specifies a drawing-units value for automatic scaling of blocks, images, or xrefs
when inserted or attached to a drawing.
IntegerType:
DrawingSaved in:
1 (imperial) or 4 (metric)Initial value:
NOTE The INSUNITS setting is ignored when inserting annotative blocks into a
drawing.
Unspecified (No units)0
Inches1
Feet2
Miles3
Millimeters4
Centimeters5
Meters6
System Variables | 1335