2012

See also:
Control the Location of Dimension Text
DIMTIX
Draws text between extension lines.
SwitchType:
DrawingSaved in:
OffInitial value:
For linear and angular dimensions, dimension text is placed inside
the extension lines if there is sufficient room.
Off
Draws dimension text between the extension lines even if it would
ordinarily be placed outside those lines. For radius and diameter
On
dimensions, DIMTIX on always forces the dimension text outside
the circle or arc.
See also:
Fit Dimension Text Within Extension Lines
DIMTM
Sets the minimum (or lower) tolerance limit for dimension text when DIMTOL
or DIMLIM is on.
RealType:
DrawingSaved in:
0.0000Initial value:
DIMTM accepts signed values. If DIMTOL is on and DIMTP and DIMTM are
set to the same value, a tolerance value is drawn.
If DIMTM and DIMTP values differ, the upper tolerance is drawn above the
lower, and a plus sign is added to the DIMTP value if it is positive.
For DIMTM, the program uses the negative of the value you enter (adding a
minus sign if you specify a positive number and a plus sign if you specify a
negative number).
1246 | Chapter 4 System Variables