2012

0.0000Initial value:
See also:
Control Dimension Lines
DIMDLI
Controls the spacing of the dimension lines in baseline dimensions.
RealType:
DrawingSaved in:
0.3800 (imperial) or 3.7500 (metric)Initial value:
Each dimension line is offset from the previous one by this amount, if
necessary, to avoid drawing over it. Changes made with DIMDLI are not
applied to existing dimensions.
See also:
Control Dimension Lines
DIMDSEP
Specifies a single-character decimal separator to use when creating dimensions
whose unit format is decimal.
Single-characterType:
DrawingSaved in:
. (imperial) or , (metric)Initial value:
When prompted, enter a single character at the Command prompt. If
dimension units is set to Decimal, the DIMDSEP character is used instead of
the default decimal point. If DIMDSEP is set to NULL (default value, reset by
entering a period), the decimal point is used as the dimension separator.
See also:
Control the Display of Dimension Units
1230 | Chapter 4 System Variables