2012

See also:
Control the Display of Dimension Units
DIMALTF
Controls the multiplier for alternate units.
RealType:
DrawingSaved in:
25.4000 (imperial) or 0.0394 (metric)Initial value:
If DIMALT is turned on, DIMALTF multiplies linear dimensions by a factor to
produce a value in an alternate system of measurement. The initial value
represents the number of millimeters in an inch.
See also:
Control the Display of Dimension Units
DIMALTRND
Rounds off the alternate dimension units.
RealType:
DrawingSaved in:
0.0000Initial value:
See also:
Control the Display of Dimension Units
DIMALTTD
Sets the number of decimal places for the tolerance values in the alternate
units of a dimension.
IntegerType:
DrawingSaved in:
2 (imperial) or 3 (metric)Initial value:
System Variables | 1217