2012

0Initial value:
Angular dimensions display the number of decimal places specified
by DIMDEC (page 1229).
-1
Specifies the number of decimal places displayed in angular dimen-
sions (independent of DIMDEC)
0-8
See also:
Create Angular Dimensions
DIMALT
Controls the display of alternate units in dimensions.
SwitchType:
DrawingSaved in:
OffInitial value:
See also
DIMALTD (page 1216), DIMALTF (page 1217), DIMALTTD (page 1217),
DIMALTTZ (page 1218), DIMALTZ (page 1219), and DIMAPOST (page 1220).
Disables alternate unitsOff
Enables alternate unitsOn
See also:
Control the Display of Dimension Units
DIMALTD
Controls the number of decimal places in alternate units.
IntegerType:
DrawingSaved in:
2 (imperial) or 3 (metric)Initial value:
If DIMALT is turned on, DIMALTD sets the number of digits displayed to the
right of the decimal point in the alternate measurement.
1216 | Chapter 4 System Variables