2012

Displays prompts to delete profile curves, including those used with
the EXTRUDE, SWEEP, REVOLVE, and LOFT commands. Prompts to
remove cross sections used with the LOFT command.
-1
The original geometry for CONVTOSOLID, CONVTOSURFACE, and
CONVTOMESH commands is removed without prompting.
Displays prompts to delete all defining geometry, including paths
and guide curves used with the SWEEP and LOFT commands.
-2
The original geometry for CONVTOSOLID, CONVTOSURFACE, and
CONTOMESH commands is removed without prompting.
Displays prompts to delete all defining geometry if the resulting
entities are a surface of any type. Deletes all original geometry res-
-3
ulting in a solid entity, original geometry for CONVTOSOLID,
CONVTOSURFACE, CONVTONURBS, and CONVTOMESH commands
is removed without prompting
See also:
Create and Combine Areas (Regions)
Create Solids and Surfaces from Lines and Curves
DEMANDLOAD
Specifies if and when to demand-load certain applications.
IntegerType:
RegistrySaved in:
3Initial value:
If you set this system variable to 0, third-party applications and some AutoCAD
commands cannot function.
Turns off demand-loading.0
Demand-loads the source application when you open a drawing
that contains custom objects. This setting does not demand-load
the application when you invoke one of the application's commands.
1
1214 | Chapter 4 System Variables