2012

NOTE You cannot use ZOOM transparently during VPOINT (page 1114) or DVIEW
(page 385) or while ZOOM, PAN (page 763), or VIEW (page 1104) is in progress.
List of Prompts
The following prompts are displayed.
Specify corner of window, enter a scale factor (nX or nXP),
or
[
All (page 1154)/Center (page 1154)/Dynamic (page 1155)/Extents
(page 1155)/Previous (page 1155)/Scale (page 1156)/Window (page
1156)/
Object (page 1157)] <real time (page 1157)>
All Zooms to display all visible objects and visual aids.
Adjusts the magnification of the drawing area to accommodate the extents
of all visible objects in the drawing, or visual aids such as the grid limits (the
LIMITS (page 573) command), whichever is larger.
In the illustration on the right, the grid limits are set to a larger area than the
extents of the drawing.
Because it always regenerates the drawing, you cannot use ZOOM All
transparently.
Center Zooms to display a view defined by a center point and a magnification
value or a height. A smaller value for the height increases the magnification.
A larger value decreases the magnification. Not available in perspective
projection.
1154 | Chapter 2 Commands