2012

Angle If Specify On-Screen is cleared, enter the rotation angle value in the
dialog box.
Path Type
Select the full (absolute) path, the relative path to the external reference file,
or No Path, the name of the external reference (the file must be located in the
same folder as the current drawing file).
Details
Displays block and path information about the external reference being
attached.
Block Displays information about the block in the drawing.
 Unit. Displays the specified
INSUNITS (page 1335) value for the inserted
block.
 Factor. Displays the unit scale factor, which is calculated based on the
INSUNITS (page 1335) value of the block and the drawing units.
Path Displays the external reference file paths.
 Found In. Displays the path where the external reference file is located.
 Saved Path. Displays the path that is saved with the drawing when the
external reference is attached. The path is dependent upon the Path Type
setting.
See also:
Attach External References
External Reference Visor
Displays options for attaching external references.
Summary
The External Reference visor is displayed when you select an external reference.
List of Options
The following options are displayed.
1140 | Chapter 2 Commands