2012

List of Prompts
The following prompts are displayed.
Specify first corner or [
Center (page ?)]: Specify a point or enter
c for center
Specify other corner or [
Cube (page ?)/Length (page ?)]:
Specify the other corner of the wedge or enteran option
If the other corner of the wedge is specified with a Z value that differs from
the first corner, then no height prompt is displayed.
Specify height or [2Point (page ?)] <default>: Specify the height
or enter 2P for the 2 Point option
Entering a positive value draws the height along the positive Z axis of the
current UCS. Entering a negative value draws the height along the negative
Z axis.
Center
Creates the wedge by using a specified center point.
Cube Creates a wedge with sides of equal length.
Length Creates a wedge with length, width, and height values you specify.
The length corresponds to the X axis, the width to the Y axis, and the height
to the Z axis. If you pick a point to specify the length, you also specify the
rotation in the XY plane.
1134 | Chapter 2 Commands