2012

The arc does not necessarily pass through this third point, as shown in the
illustration.
Angle Draws an arc counterclockwise from the start point (1) using a center
point (2) with a specified included angle. If the angle is negative, a clockwise
arc is drawn.
Specify included angle: Specify an angle
Chord Length Draws either a minor or a major arc based on the distance of
a straight line between the start point and endpoint.
If the chord length is positive, the minor arc is drawn counterclockwise from
the start point. If the chord length is negative, the major arc is drawn
counterclockwise.
Specify length of chord: Specify a length
End
Specifies the endpoint of the arc.
Specify end point of arc:
Specify center point of arc or [Angle/Direction/Radius]:
Center Point Draws an arc counterclockwise from the start point (1) to an
endpoint that falls on an imaginary ray drawn from the center point (3)
through the second point specified (2).
80 | Chapter 2 Commands