2012

Objects that Can Be Used as a Sweep PathObjects that Can Be Swept
Helices3D solid face subobjects
ArcsArcs
CirclesCircles
EllipsesEllipses
Elliptical arcsElliptical arcs
LinesLines
Regions
Solid, surface and mesh edge subob-
jects
Trace
NOTE
Select face and edge subobjects by pressing Ctrl while you select them.
To automatically delete the original geometry used to create the object, use
the
DELOBJ (page 1213) system variable. For associative surfaces (page 1452), the
DELOBJ system variable is ignored and the originating geometry is not deleted.
List of Prompts
The following prompts are displayed.
Objects to Sweep Specifies an object to use as the sweep profile.
Sweep Path Specifies the sweep path based on the object you select.
Mode Controls whether the sweep action creates a solid or a surface. Surfaces
are swept as either NURBS surfaces or procedural surfaces, depending on the
SURFACEMODELINGMODE (page 1453) system variable.
Commands | 1029