2012

The System Default option calculates the default end tangents.
Tolerance
Refits the spline to the existing fit points using the new tolerance value.
Exit
Returns to the previous prompt.
Edit Vertex
Edits control frame data using the following options:
Enter a vertex editing option [Add (page ?)/Delete (page ?)/Elevate order
(page ?)/Move (page ?)/Weight (page ?)/eXit (page ?)] <eXit>:
Add
Adds a new control vertex at the point you specify that is located between
two existing control vertices.
Delete
Removes a selected control vertex.
Elevate Order
Increases the polynomial order (degree plus one) of the spline. This results in
increasing the number of control vertices across the spline.
The maximum value is 26.
Move
Relocates a selected control vertex.

New Location (page 995)
 Next (page 995)
 Previous (page 995)
 Select Point (page 995)
Weight
Changes the weight of a specified control vertex.
996 | Chapter 2 Commands