2011

NOTE If you hold the cursor over a tool group or flyout, it will expand after
a short interval of time.
4 Release the button on the pointer device when a tool group or flyout is
highlighted, or the desired location is indicated by a horizontal line.
For information about creating a command, see Create, Edit, and Reuse
Commands
on page 44.
To insert a separator
1 At the Command prompt, enter cui and press Enter.
2 In the Customize dialog box, Tool Sets tab, Tool Sets list, select a tool
group, flyout, or command to insert a separator after.
3 Click the Options action menu below the Tool Sets list, Gear icon, and
click Insert Separator.
To duplicate a tool group, flyout, command, or separator
1 At the Command prompt, enter cui and press Enter.
2 In the Customize dialog box, Tool Sets tab, Tool Sets list, select a tool
group, flyout, command, or separator to duplicate.
3 Click the Options action menu below the Tool Sets list, Gear icon, and
click Duplicate.
4 Enter a new name for the duplicated item.
To delete a tool group, flyout, command, or separator
1 At the Command prompt, enter cui and press Enter.
2 In the Customize dialog box, Tool Sets tab, Tool Sets list, select a tool
group, flyout, command, or separator to delete.
3 Click the Options action menu below the Tool Sets list, Gear icon, and
click Delete.
NOTE Be careful which item is selected because you cannot undo the deletion
of the item. Click Cancel to abort the changes you made.
68 | Chapter 4 User Interface Customization