2011
Table Of Contents
- Contents
- Basic Customization
- Custom Linetypes
- Custom Hatch Patterns
- User Interface Customization
- DIESEL
- Command Scripts
- Introduction to Programming Interfaces
- Shapes and Shape Fonts
- Overview of Shape Files
- Create Shape Definition Files
- Shape Descriptions
- Vector Length and Direction Code
- Special Codes
- Use Special Codes
- Codes 0, 1, and 2: End of Shape and Draw Mode Control
- Codes 3 and 4: Size Control
- Codes 5 and 6: Location Save/Restore
- Code 7: Subshape
- Codes 8 and 9: X-Y Displacements
- Code 00A: Octant Arc
- Code 00B: Fractional Arc
- Codes 00C and 00D: Bulge-Specified Arcs
- Code 00E: Flag Vertical Text Command
- Text Font Descriptions
- Sample Files
- Big Font Descriptions
- Unicode Font Descriptions
- Superscripts and Subscripts in SHX Files
- Index
Specification byte codes
DescriptionCode
Multiple X-Y displacements, terminated (0,0)009
Octant arc defined by next two bytes00A
Fractional arc defined by next five bytes00B
Arc defined by X-Y displacement and bulge00C
Multiple bulge-specified arcs00D
Process next command only if vertical text00E
Quick Reference
Commands
LOAD
Makes shapes available for use by the SHAPE command.
SHAPE
Inserts a shape from a shape file that has been loaded using LOAD.
Codes 0, 1, and 2: End of Shape and Draw Mode Control
Code 0 marks the end of the shape definition, and Codes 1 and 2 control
Draw mode.
Draw is activated at the start of each shape. When Draw mode is turned on
(code 1), the vectors cause lines to be drawn. When Draw mode is turned off
(code 2), the vectors move to a new location without drawing.
Quick Reference
Commands
LOAD
Makes shapes available for use by the SHAPE command.
Special Codes | 111