2011

■ Undo
■ Remove
■ All
All Selects all faces and adds them to the selection set.
■ Select faces. Selects specific faces (instead of all of them).
■ Undo
■ Remove
Height of extrusion Sets the direction and distance of the extrusion. Entering
a positive value extrudes the face in the direction of its normal. Entering a
negative value extrudes the face in the direction opposite to its normal.
■ Angle of taper for extrusion. Specify an angle between -90 and +90 degrees.
958 | Chapter 19 S Commands