2011

■ Select a surface. Specifies a surface to be used for alignment.
NOTE You cannot select meshes created with the EDGESURF, REVSURF,
RULESURF, and TABSURF commands.
■
Point on desired side
■ Keep both sides
Z axis Defines the cutting plane by specifying a point on the plane and another
point on the Z axis (normal) of the plane.
■ Specify a point on the section plane. Sets a point on the slicing plane.
■ Specify a point on the Z-axis (normal) of the plane. Specifies a point that
defines the axis that is perpendicular to the slicing plane.
■ Point on desired side
■ Keep both sides
View Aligns the cutting plane with the current viewport's viewing plane.
Specifying a point defines the location of the cutting plane.
948 | Chapter 19 S Commands