2011

Remove mode is to hold down Shift while selecting single objects or use the
Automatic option.
Multiple Selects objects individually without highlighting them during object
selection. This speeds up object selection for highly complex objects.
Previous Selects the most recent selection set. The Previous selection set is
cleared by operations that delete objects from the drawing.
NOTE The Previous selection set is ignored if you switch spaces.
Undo Cancels the selection of the object most recently added to the selection
set.
Auto Switches to automatic selection: pointing to an object selects the object.
Pointing to a blank area inside or outside an object forms the first corner of
a box defined by the Box method. Auto and Add are the default methods.
Single Switches to the Single method: selects the first object or set of objects
designated rather than continuing to prompt for further selections.
Subobject Allows you to select original individual forms that are part of
composite solids or vertices, edges, and faces on 3D solids. You can select one
of these subobjects, or create a selection set of more than one subobject. Your
selection set can include more than one type of subobject.
Pressing and holding the Ctrl key is the same as selecting the SELECT
command’s Subobject option.
Object Ends the ability to select subobjects. Allows you to use object selection
methods.
SELECTSIMILAR
Quick Reference
See also:
■ Select Objects by Properties
938 | Chapter 19 S Commands