2011

After you enter the second set of points, you are prompted to scale the object.
The distance between the first and second destination points (2, 4) is used as
the reference length to which the object is scaled. Scaling is available only
when you are aligning objects using two point pairs.
NOTE If you use two source and destination points to perform a 3D alignment
on nonperpendicular working planes, you get unpredictable results.
ALIGN Using Three Pairs of Points When you select three point pairs, you
can move and rotate the selected objects in 3D to align with other objects.
The selected objects move from the source point (1) to the destination point
(2).
The selected object is rotated (1 and 3) so that it aligns with the destination
object (2 and 4).
The selected object is then rotated again (3 and 5) so that it aligns with the
destination object (4 and 6).
AMECONVERT
Quick Reference
See also:
■ Use Models with Other Applications
Converts AME solid models to AutoCAD solid objects.
Summary
The objects you select must be Advanced Modeling Extension (AME) Release
2 or 2.1 regions or solids. All other objects are ignored.
60 | Chapter 2 A Commands