2011

List of Prompts
The following prompts are displayed.
Current settings: Rotation = 0
Specify first corner point or [Chamfer/Elevation/Fillet/Thickness/Width]:
Specify a point or enter an option
First Corner Point
Specifies a corner point of the rectangle.
Other Corner Point Creates a rectangle using the specified points as diagonally
opposite corners.
Area Creates a rectangle using the area and either a length or a width. If the
Chamfer or Fillet option is active, the area includes the effect of the chamfers
or fillets on the corners of the rectangle.
Dimensions Creates a rectangle using length and width values.
Rotation Creates a rectangle at a specified rotation angle.
Chamfer
Sets the chamfer distances for the rectangle.
Elevation
Specifies the elevation of the rectangle.
Fillet
Specifies the fillet radius of the rectangle.
Thickness
Specifies the thickness of the rectangle.
Width
Specifies the polyline width of the rectangle to be drawn.
866 | Chapter 18 R Commands