2011

Close Closes the solid by creating a line or arc segment from the last point
specified to the starting point of the solid. At least three points must be
specified to use this option.
Undo Removes the most recent arc segment added to the solid.
Arc
Adds an arc segment to the solid. The default starting direction of the arc is
tangent to the last drawn segment. You can specify a different starting direction
with the Direction option.
Specify endpoint of arc or [Close/Direction/Line/Second point/Undo]: Specify
an endpoint or enter an option
Close Closes the solid by creating a linear or arc segment from the last vertex
to the start of the solid.
Direction Specifies a starting direction for the arc segment.
Specify the tangent direction from the start point of arc: Specify a point
Specify endpoint of arc: Specify a point
Line Exits the Arc option and returns to the initial POLYSOLID command
prompts.
Second Point Specifies the second point and endpoint of a three-point arc
segment.
Specify second point on arc: Specify a point
Specify end point of arc: Specify a point
Undo Removes the most recent arc segment added to the solid.
Undo
Removes the most recent segment added to the solid.
PRESSPULL
Quick Reference
See also:
■ Press or Pull Bounded Areas
Presses or pulls bounded areas.
PRESSPULL | 825