2011

Width
Specifies the width of the solid. The default width is set to the current
PSOLWIDTH setting.
Specify width <current>: Specify a value for the width by entering a value or
specifying two points, or press Enter to specify the current width value
The specified width value will update the PSOLWIDTH setting.
Justify
Sets the width and height as the solid to be left, right, or center justified when
defining the profile with the command. The justification is based on the
starting direction of the first segment of the profile.
Enter justification [Left/Center/Right] <Center>: Enter an option for the justification
or press Enter to specify center justification
Next Point
Specify the next point or [Arc/Close/Undo]: Specify the next point for the profile
of the solid, enter an option, or press Enter to end the command
Arc Adds an arc segment to the solid. The default starting direction of the arc
is tangent to the last drawn segment. You can specify a different starting
direction with the Direction option.
Specify endpoint of arc or [Close/Direction/Line/Second point/Undo]: Specify
an endpoint or enter an option
■ Close. Closes the solid by creating a line or arc segment from the last point
specified to the starting point of the solid. At least two points must be
specified to use this option.
■ Direction. Specifies a starting direction for the arc segment.
Specify the tangent direction from the start point of arc: Specify a point
Specify endpoint of arc: Specify a point
■ Line. Exits the Arc option and returns to the initial POLYSOLID command
prompts.
■ Second Point. Specifies the second point and endpoint of a three-point
arc segment.
Specify second point on arc: Specify a point
Specify end point of arc: Specify a point
■ Undo. Removes the most recent arc segment added to the solid.
824 | Chapter 16 P Commands