2011

Plots a drawing to a plotter, printer, or file in the command line.
If you enter -plot at the Command prompt, the following prompts are
displayed.
List of Prompts
The following prompts are displayed.
Detailed plot configuration [Yes on page 799/No on page 799] <No>: Enter y or
n or press ENTER
No
Indicates that you do not want a detailed plot configuration for this plot.
Enter a layout name or [?] <current>:
Enter a page setup name < >:
Enter an output device name or [?] <current>:
Write the plot to a file [Yes/No] <current>:
Enter file name: <dwgname-layoutname.plt>:
Save changes to layout [Yes/No] <No>:
Proceed with Plot [Yes/No] <Y>:
For information about these prompts, see the description for Yes.
Yes
Specifies detailed page settings for the Model tab or layout tab you are plotting.
Enter a layout name or [?] <current>: Specify the name of the layout tab you want
to plot
Enter an output device name or [?] <current>: Specify the name of the output
device to which you want to plot the Model tab or layout tab you selected
If you enter a new device name without an extension, the program assumes
that the device is a PC3 file (Autodesk
®
HDI plotter configuration file). If no
PC3 file is found, the program searches for a Windows system printer with
that device name.
Enter paper size or [?] <current>: Specify the paper size to use for the plot or enter
? to view the actual list of paper sizes defined for the plotter driver
You must specify a paper size exactly as it is defined by the plotter driver.
Enter paper units [Inches/Millimeters] <current>:
-PLOT | 799