2011

Table Of Contents
Nopen
Opens the N-direction polylines if the polygon mesh is closed in the N
direction.
Undo
Reverses operations as far back as the beginning of the PEDIT session.
PFACE
Quick Reference
See also:
Create Custom Mesh (Legacy)
Creates a 3D polyface mesh vertex by vertex.
List of Prompts
The following prompts are displayed.
Specify
location for vertex on page 782 1: Specify a point
Specify location for vertex 2 or <
define faces on page 782>: Specify a point or
press Enter
Specify location for vertex n or <define faces>: Specify a point or press Enter
Vertex Location
You specify all vertices used in the mesh. The vertex numbers displayed in
the prompts are the numbers used to reference each vertex. The prompt is
repeated until you press Enter. If you press Enter on a blank line, you are
prompted for the vertices to be assigned to each face.
Define Faces
Vertex Number You define each face by entering vertex numbers for all the
vertices of that face. The mesh is drawn after you have defined the last face
and pressed Enter after the prompt.
782 | Chapter 16 P Commands