2011

Table Of Contents
3D Polygon Mesh Selection (PEDIT)
Quick Reference
If you select a polygon mesh, the following prompt is displayed:
List of Prompts
The following prompts are displayed.
Enter an option [Edit vertex/Smooth surface/Desmooth/Mclose/Nclose/Undo]:
Enter an option or press Enter to end the command
Mclose and Nclose are replaced by Mopen and Nopen if the polygon mesh is
currently closed in the M or N direction.
Edit Vertex
Edits individual vertices of a polygon mesh that can be seen as a rectangular
M by N array, where M and N are the dimensions specified in 3DMESH. The
SURFTAB1 and SURFTAB2 system variables store M and N values for RULESURF,
TABSURF, REVSURF, and EDGESURF.
Pressing Enter accepts the current default, which is either Next or Previous.
Next Moves the X marker to the next vertex. The marker does not wrap around
from the end to the start of the mesh, even if the mesh is closed.
Previous Moves the X marker to the previous vertex. The marker does not
wrap around from the start to the end of the mesh, even if the mesh is closed.
Left Moves the X marker to the previous vertex in the N direction. The marker
does not wrap around from the start to the end of the mesh, even if the mesh
is closed.
Right Moves the X marker to the next vertex in the N direction. The marker
does not wrap around from the end to the start of the mesh, even if the mesh
is closed.
780 | Chapter 16 P Commands