2011

Table Of Contents
Ortho mode is used when you specify an angle or distance by means of two
points using a pointing device. In Ortho mode, cursor movement is constrained
to the horizontal or vertical direction relative to the UCS.
Horizontal is defined as being parallel to the X axis of the UCS and vertical as
being parallel to the Y axis.
In a 3D view, ORTHO is additionally defined as being parallel to the Z axis of
the UCS, and the tooltip displays +Z or -Z for the angle depending on the
direction along the Z axis.
OSNAP
Quick Reference
See also:
Use Object Snaps
Sets running object snap modes.
Access Methods
Menu: Tools Drafting Settings
Toolbar: Status bar Osnap
Shortcut menu: Press Shift while right-clicking in the drawing area and
choose Osnap Settings.
Command entry: 'osnap for transparent use
Summary
The Object Snap tab of the
Drafting Settings dialog box is displayed.
If you enter -osnap at the Command prompt, the following prompts are
displayed.
OSNAP | 745