2011

Exit Exits the OFFSET command.
Multiple Enters the Multiple offset mode, which repeats the offset operation
using the current offset distance.
Undo Reverses the previous offset.
Through
Creates an object passing through a specified point.
NOTE For best results when you offset a polyline with corners, specify the through
point near the midpoint of a line segment, not near a corner.
■ Exit on page 721
■ Multiple on page 721
■ Undo on page 721
Erase
Erases the source object after it is offset.
Layer
Determines whether offset objects are created on the current layer or on the
layer of the source object.
OFFSET | 721