2011

Specify insertion point or [Basepoint on page 645/Scale/X/Y/Z/Rotate]: Specify
a point or enter an option
Insertion Point
Specifies a location for the blocks.
Enter X scale factor, specify opposite corner, or [Corner/XYZ] <1>: Enter a value,
enter an option, or press Enter
X Scale Factor Sets X and Y scale factors.
Specify Rotation Angle The rotation angle sets the angle of the individual
block inserts and also sets the angle of the entire array.
Number of Rows/Columns Specifies the number of rows and columns in the
array.
Distance Between Rows Specifies the distance (in units) between rows. You
can use the pointing device to specify the distance between rows, or specify
two points to define a box whose width and height represent the distance
between rows and between columns.
Distance Between Columns Specifies the distance (in units) between columns.
Corner Sets the scale factor by using the block insertion point and the opposite
corner.
■
Specify Rotation Angle on page 644
■
Number of Rows/Columns on page 644
■
Distance Between Rows on page 644
■
Distance Between Columns on page 644
XYZ Sets X, Y, and Z scale factors.
■
X Scale Factor on page 644
■
Corner on page 644
■
Specify Rotation Angle on page 644
■
Number of Rows/Columns on page 644
■
Distance Between Rows on page 644
■
Distance Between Columns on page 644
644 | Chapter 13 M Commands