2011

2P (torus diameter) Sets the diameter of the mesh torus by specifying two
points. The diameter is calculated from the center point of the torus to the
center point of the tube.
■ First endpoint of diameter. Sets the first point used to specify the torus
diameter distance.
■ Second endpoint of diameter. Sets the second point used to specify the
torus diameter distance.
■
Tube radius
■ 2Point (tube radius)
■ Diameter (tube)
Ttr (tangent, tangent, radius) Defines a mesh torus radius that is tangent to
two objects. The specified tangent points are projected into the current UCS:
■ Point on object for first tangent. Sets a point on an object to serve as the
first tangent point.
■ Point on object for second tangent. Sets a point on an object to serve as
the second tangent point.
■ Radius of circle. Sets the radius of the mesh torus.
If the specified criteria can produce multiple results, the closest tangent points
are used.
Radius (torus) Sets the radius of the mesh torus, measured from the center
point of the torus to the center point of the tube.
■
Tube radius
■ 2Point (tube radius)
■ Diameter (tube)
Diameter (torus) Sets the diameter of the mesh torus, measured from the
center point of the torus to the center point of the tube.
■
Tube radius
■ 2Point (tube radius)
■ Diameter (tube)
626 | Chapter 13 M Commands