2011

Sphere
Creates a 3D mesh sphere.
Specify the size of the sphere (diameter or radius).
Center point Sets the center point of the sphere.
■ Radius. Creates a mesh sphere based on a specified radius.
■ Diameter. Creates a mesh sphere based on a specified diameter.
3P (three points) Sets the location, size, and plane of the mesh sphere by
specifying three points:
■ First point. Sets the first point on the circumference of the mesh sphere.
■ Second point. Sets a second point on the circumference of the mesh sphere.
■ Third point. Sets the size and planar rotation of the mesh sphere.
2P (diameter) Sets the diameter of the mesh sphere by specifying two points:
■ First endpoint of diameter. Sets the first point on the diameter of the mesh
sphere.
■ Second endpoint of diameter. Sets the opposite point on the diameter of
the mesh sphere.
622 | Chapter 13 M Commands