2011

■ Path
■ Cross sections only
■ Settings on page 580
Continuity This option only displays if the
LOFTNORMALS on page 1397 system
variable is set to 1 (smooth fit). Specifies whether the continuity is G0, G1, or
G2 where the surfaces meet.
Bulge Magnitude This option only displays if the
LOFTNORMALS on page
1397 system variable is set to 1 (smooth fit). Specifies a bulge magnitude value
for objects that have a continuity of G1 or G2.
Guides
Specifies guide curves that control the shape of the lofted solid or surface.
You can use guide curves to control how points are matched up on
corresponding cross sections to prevent undesired results, such as wrinkles in
the resulting solid or surface.
■ Intersects each cross section
■ Starts on the first cross section
■ Ends on the last cross section
Select any number of guide curves for the lofted surface or solid and press
Enter.
Path
Specifies a single path for the lofted solid or surface.
LOFT | 579