2011

Objects That Can Be
Used as Guides
Objects That Can Be
Used as a Loft Path
Objects That Can Be
Used as Cross Sec-
tions
Edge subobjectsEdge subobjectsEdge sub-objects
3D polylineEllipseEllipse
Elliptical arcElliptical arcElliptical arc
2D polylineHelix
LineLineLine
Planar or non-planar
face of solid
Planar or non-planar
surface
3D polylinePoints (first and last
cross section only)
Region
Trace
To automatically delete the cross sections, guides, and paths, use DELOBJ. If
surface associativity on page 1507 is on, DELOBJ is ignored and the originating
geometry is not deleted.
List of Prompts
The following prompts are displayed.
Cross Sections in Lofting Order Specifies open or closed curves in the order
in which the surface or solid will pass through them.
Point If you select the Point option, you must also select a closed curve.
Join Multiple Curves Joins multiple, end-to-end curves as one cross section.
Mode Controls whether the lofted object is a solid or a surface.
Options
■
Guides
578 | Chapter 12 L Commands