2011

Angle Changes the included angle of the selected arc by the specified angle.
Percent
Sets the length of an object by a specified percentage of its total length.
Total
Sets the length of a selected object by specifying the total absolute length from
the fixed endpoint. Total also sets the included angle of a selected arc by a
specified total angle.
Total Length Lengthens the object to the specified value from the endpoint
that is closest to the selection point.
Angle Sets the included angle of the selected arc.
Dynamic
Turns on Dynamic Dragging mode. You change the length of a selected object
by dragging one of its endpoints. The other end remains fixed.
564 | Chapter 12 L Commands