2011

Table Of Contents
Use IMAGE Reload to update its definition.
Specify insertion point <0,0>: Specify an insertion point
Base image size: Width: current width, Height: current height, current unit
Specify scale factor: Enter a value or press Enter
Specify rotation angle <0>: Enter a value or press Enter
If the FILEDIA system variable is set to 0, the following prompt is displayed
instead of the dialog box:
Enter image file name to attach <last>: Enter an image name
The last image name attached to the drawing during the current session is the
default. To avoid errors when entering an image name, it is recommended
that you specify both the image name and the file name as follows:
imagename=path name\long file name.bmp
or
imagename="path name\long file name.bmp"
If you enter a valid image name without a file extension, the program searches
for the file in this order: first, an existing image definition in the drawing,
and second, an image file in the folders in order of the search path. The
program searches for all the image files with the specified name, regardless of
extension, and uses the first name found. If no image name or image file is
found, the message Image Not Found is displayed and the prompt is repeated.
To specify a long file name that does not conform to this program's naming
rules, enter the name as follows:
"imagename=filename"
You can use a dialog box to search for image files but still enter the
imagename=filename convention at the Command prompt. Enter a tilde (~) at
the Enter Image File Name to Attach prompt. If you press Esc after the dialog
box opens, the Enter Image Name prompt is displayed.
508 | Chapter 10 I Commands