2011

-Y Runs a line in the negative Y direction from the point you specify to the
first object encountered and then traces the boundary in a counterclockwise
direction.
Angle Runs a line at the specified angle from the point you specify to the first
object encountered and then traces the boundary in a counterclockwise
direction.
Style
Specifies the method used to hatch or fill objects within the outermost hatch
boundary. If you have selected no internal objects, a hatching style has no
effect. Because you can define a precise set of boundaries, it's often best to use
the Normal style.
Ignore Ignores all internal objects and hatches or fills through them.
Outer (Recommended) Hatches or fills inward from the outer boundary.
HATCH turns hatching or filling off if it encounters an internal island. This
490 | Chapter 9 H Commands