2011

Specifies an angle for the hatch pattern relative to the X axis of the current
UCS. (HPANG system variable)
Scale
Expands or contracts a predefined or custom pattern. This option is available
only when Type is set to Predefined or Custom. (HPSCALE system variable)
Double
For user-defined patterns, draws a second set of lines at 90 degrees to the
original lines, creating a crosshatch. This option is available only when Type
is set to User Defined. (HPDOUBLE system variable)
Relative to Paper Space
Scales the hatch pattern relative to paper space units. This allows you to display
hatch patterns at a scale that is appropriate for your named layout. This option
is available only from a named layout.
Spacing
Specifies the spacing of lines in a user-defined pattern. This option is available
only when Type is set to User Defined. (HPSPACE system variable)
ISO Pen Width
Scales an ISO predefined pattern based on the selected pen width. This option
is available only when Type is set to Predefined and Pattern is set to one of
the available ISO patterns.
Hatch Origin
Controls the starting location of hatch pattern generation. Some hatches,
such as brick patterns, are meant to be aligned with a point on the hatch
boundary. By default, all hatch origins correspond to the current UCS origin.
Use Current Origin
Uses the hatch origin point stored in the
HPORIGIN on page 1361 system
variable.
Specified Origin
Assigns a new hatch origin using the following options.
Click to Set New Origin
Specifies the new hatch origin point directly.
Default to Boundary Extents
Hatch and Gradient Dialog Box | 479