2011

Table Of Contents
Attenuation Start Limit Specifies the point where light starts as an offset
from the center of the light. The default is 0.
Attenuation End Limit Specifies the point where light ends as an offset from
the center of the light. No light is cast beyond this point. Setting an end limit
increases performance where the effect of lighting is so minimal that the
calculations are wasted processing time.
Color/Filter Color
Controls the color of the light.
True Color Specifies a True Color. Enter in the format R,G,B (red, green, blue).
Index Specifies an ACI (AutoCAD Color Index) color.
HSL Specifies an HSL (hue, saturation, luminance) color.
Color Book Specifies a color from a color book.
FREEWEB
Quick Reference
See also:
Overview of Weblights
Creates a free web light which is similar to a web light without a specified
target.
List of Prompts
The following prompts are displayed.
Specify source location <0,0,0>: Enter coordinate values or use the pointing device
Enter an option to change [
Name/Intensity
factor
/Status/Photometry/weB/shadoW/filterColor/eXit] <eXit>:
NOTE The LIGHTINGUNITS system variable must be set to a value other than 0
to create and use freeweb lights.
Name
Specifies the name of the light. You can use uppercase and lowercase letters,
numbers, spaces, hyphens (-), and underscores (_) in the name. The maximum
length is 256 characters.
FREEWEB | 445