2011

Toggle (Angle From) Switches between two angle input modes. Entering an
angle at the Command prompt locks the cursor movement so you see only
the positions available for that angle. Toggle unlocks the cursor movement
for the angle, and you can use the cursor to rotate the camera.
Target
Specifies a new position for the target by rotating it around the camera. The
effect is like turning your head to see different parts of the drawing from one
vantage point. Two angles determine the amount of rotation.
Enter Angle from the XY Plane
Enter Angle from the XY Plane on page 382
Toggle (Angle In)
Toggle (Angle In) on page 382
Enter Angle in XY Plane from X Axis
Enter Angle in XY Plane from X Axis
on page 382The illustration shows the effect of moving the target point from
left to right, leaving its angle from the XY plane unchanged.
Toggle (Angle From) Toggle (Angle From) on page 383
Distance
Moves the camera in or out along the line of sight relative to the target. This
option turns on perspective viewing, which causes objects farther from the
camera to appear smaller than those closer to the camera. A special perspective
icon replaces the coordinate system icon. You are prompted for the new
camera-to-target distance.
DVIEW | 383