2011

Table Of Contents
Object Snap Tab (Drafting Settings Dialog Box)
Controls running object snap settings. With running object snap settings, also
called Osnap, you can specify a snap point at an exact location on an object.
When more than one option is selected, the selected snap modes are applied
to return a point closest to the center of the aperture box. Press TAB to cycle
through the options.
Object Snap On
Turns running object snaps on and off. The object snaps selected under Object
Snap Modes are active while object snap is on. (OSMODE system variable)
Object Snap Tracking On
Turns object snap tracking on and off. With object snap tracking, the cursor
can track along alignment paths based on other object snap points when
specifying points in a command. To use object snap tracking, you must turn
on one or more object snaps. (AUTOSNAP system variable)
Object Snap Modes
Lists object snaps that you can turn on as running object snaps.
Drafting Settings Dialog Box | 365