2011

Table Of Contents
set on the Polar Tracking tab relative to the starting polar tracking point.
(SNAPTYPE system variable)
Grid On
Turns the grid on or off. You can also turn grid mode on or off by clicking
Grid on the status bar, by pressing F7, or by using the
GRIDMODE on page
1338 system variable.
Grid Style
Sets the grid style in 2D contexts. You can also set grid style by using the
GRIDSTYLE on page 1339 system variable.
2D Model Space
Sets the grid style to dotted grid for 2D model space. (
GRIDSTYLE on page 1339
system variable)
Block Editor
Sets the grid style to dotted grid for the Block Editor. (
GRIDSTYLE on page
1339 system variable)
Sheet/Layout
Sets the grid style to dotted grid for sheet and layout. (
GRIDSTYLE on page
1339 system variable)
Grid Spacing
Controls the display of a grid that helps you visualize distances.
NOTE The limits of the grid are controlled by the LIMITS command and the
GRIDDISPLAY system variable.
Grid X Spacing
Specifies the grid spacing in the X direction. If this value is 0, the grid assumes
the value set for Snap X Spacing. (GRIDUNIT system variable)
Grid Y Spacing
Specifies the grid spacing in the Y direction. If this value is 0, the grid assumes
the value set for Snap Y Spacing. (GRIDUNIT system variable)
Major Line Every
Specifies the frequency of major grid lines compared to minor grid lines. Grid
lines rather than grid dots are displayed when GRIDSTYLE on page 1339 is set
to 0. (GRIDMAJOR system variable)
Drafting Settings Dialog Box | 361