2011

List of Prompts
The following prompts are displayed.
Specify inside diameter of donut <current>: Specify a distance or press Enter
If you specify an inside diameter of 0, the donut is a filled circle.
Specify outside diameter of donut <current>: Specify a distance or press Enter
Specify center of donut or <exit>: Specify a point (1) or press Enter to end the
command
The location of the donut is set based on the center point. After you specify
the diameters, you are prompted for the locations at which to draw donuts.
A donut is drawn at each point specified (2). How the interior of a donut is
filled depends on the current setting of the FILL command.
DRAGMODE
Quick Reference
See also:
■ Set Up the Drawing Area
Controls the way dragged objects are displayed.
DRAGMODE | 355