2011

Table Of Contents
If you specify tolerances, the suffix is added to the tolerances as well as to the
main dimension.
For more information, see Control Codes and Special Characters on page 1045.
Scale Factor Sets a scale factor for linear dimension measurements. It is
recommended that you do not change this value from the default value of
1.00. For example, if you enter 2, the dimension for a 1-inch line is displayed
as two inches. The value does not apply to angular dimensions and is not
applied to rounding values or to plus or minus tolerance values. (DIMLFAC
system variable)
Apply to Layout Dimension Only Applies the measurement scale factor only
to dimensions created in layout viewports. Except when using nonassociative
dimensions, this setting should remain unchecked. (DIMLFAC system variable)
Zero Suppression
Controls the suppression of leading and trailing zeros and of feet and inches
that have a value of zero. (DIMZIN system variable)
Zero suppression settings also affect real-to-string conversions performed by
the AutoLISP
®
rtos and angtos functions.
Leading
Suppresses leading zeros in all decimal dimensions. For example, 0.5000
becomes .5000. Select leading to enable display of dimension distances less
than one unit in sub units.
Sub-units factor
Sets the number of sub units to a unit. It is used to calculate the dimension
distance in a sub unit when the distance is less than one unit. For example,
enter 100 if the suffix is m and the sub-unit suffix is to display in cm.
Sub-unit suffix
Includes a suffix to the dimension value sub unit. You can enter text or use
control codes to display special symbols. For example, enter cm for .96m to
display as 96cm.
Trailing
Suppresses trailing zeros in all decimal dimensions. For example, 12.5000
becomes 12.5, and 30.0000 becomes 30.
0 Feet
Suppresses the feet portion of a feet-and-inches dimension when the distance
is less than one foot. For example, 0'-6 1/2" becomes 6 1/2".
New, Modify, and Override Dimension Style Dialog Boxes | 331