2011

Valid Constraint PointsObjects
CenterEllipse, Circle
Endpoints, midpoints of line and arc sub-
objects, center of arc subobjects
Polyline
Insertion pointBlock, Xref, Text, Mtext, Attribute, Table
After you specify the dimensional constraint type, you can either enter an
expression value or accept the default (constraintname=value).
The DIMCONSTRAINT command gives the same options as the following
commands:
Linear (
DCLINEAR on page 252) Creates a horizontal, vertical, or rotated
constraint based on the locations of the extension line origins and the
dimension line.
Horizontal (
DCHORIZONTAL on page 251) Constrains the X distance between
points on an object, or between two points on different objects.
Vertical (DCVERTICAL on page 254) Constrains the Y distance between points
on an object, or between two points on different objects.
Aligned (DCALIGNED on page 243) Constrains the distance between two
points on different objects.
Angular (DCANGULAR on page 245) Constrains the angle between line or
polyline segments, the angle swept out by an arc or a polyline arc segment,
or the angle between three points on objects.
Radius (
DCRADIUS on page 253) Constrains the radius of a circle or an arc.
Diameter (
DCDIAMETER on page 248) Constrains the diameter of a circle or
an arc.
Form (DCFORM on page 250) Specifies whether the dimensional constraint
being created is dynamic or annotational.
Convert (DCCONVERT on page 247) Converts associative dimensions to
dimensional constraints.
DIMCONSTRAINT | 277