2011

Table Of Contents

Second Extension Line Origin By default, the first extension line of the base

dimension is used as the extension line origin for the baseline dimension. To

override this default behavior, explicitly select the base dimension; the

extension line origin becomes the extension line of the base dimension closest

to the pick point of the selection. When you select a second point, the baseline

dimension is drawn and the Specify a Second Extension Line Origin prompt

is redisplayed. To end the command, press Esc. To select another linear,

ordinate, or angular dimension to use as the basis for the baseline dimension,

press Enter.

Feature Location Uses the endpoint of the base dimension as the endpoint

for the baseline dimension; you are prompted for the next feature location.

When you select a feature location, the baseline dimension is drawn and the

Specify Feature Location prompt is redisplayed. To select another linear,

ordinate, or angular dimension to use as the basis for the baseline dimension,

press Enter.

Undo Undoes the last baseline dimension entered during this command

session.

Select Prompts you to select a linear, ordinate, or angular dimension to use

as the base for the baseline dimension.

DIMBREAK

Quick Reference