2011

Specifies the number of control vertices in the U direction. (REBUILDU on
page 1468 system variable)
In V Direction
Specifies the number of control vertices in the V direction. (
REBUILDV on
page 1469 system variable)
Degree
Specifies the number of control vertices available per span. The higher the
number, the more complex the surface.
In U Direction
Specifies the degree of the NURBS surface in the U direction.
(REBUILDDEGREEU on page 1467 system variable)
In V Direction
Specifies the degree of the NURBS surface in the V direction.
(
REBUILDDEGREEV on page 1467 system variable)
Options
Specifies the build options. (
REBUILDOPTIONS on page 1468 system variable)
Delete Input Geometry
Specifies whether the original surface is retained along with the rebuilt surface.
(
REBUILDOPTIONS on page 1468 system variable)
Retrim Previously Trimmed Surface
Specifies whether trimmed areas from the original surface are applied to the
rebuilt surface. (
REBUILDOPTIONS on page 1468 system variable)
Preview Displays a preview of the surface before changes are applied.
Maximum Deviation
Displays the maximum deviation between the original surface and the new
one.
236 | Chapter 4 C Commands