2011

Table Of Contents
3P (Three Points)
Defines the base circumference and base plane of the cone by specifying three
points.
2Point on page 199
Axis Endpoint on page 199
Top Radius on page 199
2P (Two Points)
Defines the base diameter of the cone by specifying two points.
2Point on page 199
Axis Endpoint on page 199
Top Radius on page 199
TTR (Tangent, Tangent, Radius)
Defines the base of the cone with a specified radius tangent to two objects.
Sometimes, more than one base matches the specified criteria. The program
draws the base of the specified radius whose tangent points are closest to the
selected points.
2Point on page 199
Axis Endpoint on page 199
Top Radius on page 199
Elliptical
Specifies an elliptical base for the cone.
200 | Chapter 4 C Commands