2011

List of Prompts
The following prompts are displayed.
Specify center point of base or [
3P on page 200/2P on page 200/Ttr on page
200/
Elliptical on page 200]: Specify a point (1) or enter an option
Specify base radius or [
Diameter on page 199] <default>: Specify a base radius,
enter d to specify a diameter, or press Enter to specify the default base radius value
Specify height or [2Point on page 199/Axis endpoint on page 199/Top radius
on page 199] <default>: Specify a height, enter an option, or press Enter to specify
the default height value
Center Point of Base
2Point Specifies that the height of the cone is the distance between the two
specified points.
Axis Endpoint Specifies the endpoint location for the cone axis. The axis
endpoint is the top point of the cone or the center point of the top face of
the cone frustum (Top Radius option). The axis endpoint can be located
anywhere in 3D space. The axis endpoint defines the length and orientation
of the cone.
Top Radius Specifies the top radius of the cone, creating a cone frustum.
Initially, the default top radius is not set to any value. During a drawing session,
the default value for the top radius is always the previously entered top radius
value for any solid primitive.
Diameter Specifies the diameter for the base of the cone.
Initially, the default diameter is not set to any value. During a drawing session,
the default value for the diameter is always the previously entered diameter
value for any solid primitive.
CONE | 199