2011

0.0000,0.0000,1.0000Initial value:
Stores the viewing direction in the current viewport, expressed in UCS
coordinates.
This describes the camera point as a 3D offset from the target point.
VIEWMODE
Quick Reference
See also:
■ Save and Restore Views
(Read-only)
IntegerType:
DrawingSaved in:
0Initial value:
Stores the View mode for the current viewport.
The setting is stored as a bitcode using the sum of the following values:
Turned off.0
Perspective view active.1
Front clipping on2
Back clipping on.4
UCS Follow mode on.8
Front clip not at eye. If on, the front clip distance
(FRONTZ) determines the front clipping plane. If off,
16
FRONTZ is ignored, and the front clipping plane is set to
pass through the camera point (vectors behind the camera
are not displayed). This flag is ignored if the front-clipping
bit (2) is off.
1550 | Chapter 47 V System Variables