2011

SPLINESEGS
Quick Reference
See also:
■ Modify Polylines
IntegerType:
DrawingSaved in:
8Initial value:
Sets the number of line segments to be generated for each spline-fit polyline
generated by the Spline option of the PEDIT command.
Enter a non-zero integer between -32768 to 32767. If you set SPLINESEGS to
a negative value, segments are generated using the absolute value of the setting
and then a fit-type curve is applied to those segments. Fit-type curves use arcs
as the approximating segments. Using arcs yields a smoother generated curve
when few segments are specified, but the curve can take longer to generate.
SPLINETYPE
Quick Reference
See also:
■ Modify Polylines
IntegerType:
DrawingSaved in:
6Initial value:
Sets the type of curve generated by the Spline option of the PEDIT command.
Quadratic B-spline5
Cubic B-spline6
SPLINESEGS | 1499