2011

Table Of Contents
Controls the linetype scaling of objects displayed in paper space viewports.
No special linetype scaling. Linetype dash lengths are
based on the drawing units of the space (model or paper)
0
in which the objects were created. Scaled by the global
LTSCALE factor.
Viewport scaling governs linetype scaling. If TILEMODE is
set to 0, dash lengths are based on paper space drawing
1
units, even for objects in model space. In this mode,
viewports can have varying magnifications, yet display
linetypes identically. For a specific linetype, the dash
lengths of a line in a viewport are the same as the dash
lengths of a line in paper space. You can still control the
dash lengths with LTSCALE
When you change PSLTSCALE or use a command such as ZOOM with
PSLTSCALE set to 1, objects in viewports are not automatically regenerated
with the new linetype scale. Use the REGEN or REGENALL command to update
the linetype scales in each viewport.
PSOLHEIGHT
Quick Reference
See also:
Create a Polysolid
RealType:
DrawingSaved in:
4.0000 (imperial) or 80.0000 (metric)Initial value:
Controls the default height for a swept solid object created with the
POLYSOLID command.
The value reflects the last entered height value when using the
POLYSOLID
on page 822 command. You cannot enter 0 as the value.
PSOLHEIGHT | 1457