2011

Start and End cross sections4
All cross sections5
Use draft angle and magnitude6
LOFTPARAM
Quick Reference
See also:
■ Create a Solid or Surface by Lofting
BitcodeType:
DrawingSaved in:
7Initial value:
Controls the shape of lofted solids and surfaces.
The setting is stored as a bitcode using the sum of the following values:
No twist (minimizes the twist between cross sections)1
Align direction (aligns the start to end direction of each
cross section curve)
2
Simplify (produces simple solids and surfaces, such as a
cylinder or plane, instead of spline solids and surfaces)
4
Close (closes the surface or solid between the first and the
last cross sections)
8
1398 | Chapter 37 L System Variables